|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-04-2005, 03:30 PM
|
|||
|
|||
|
Quirk when starting sagetv 2.1
I wondered if anyone has had this issue with sagetv 2.1:
I have a hauppauge 250 tuner card installed and connected to a directv satellite tuner. When i start sagetv up, i get a black screen. I was about to jettison sage and go with BTV, until after tinkering with Sage i got it to work with the following: I go into the setup wizard and switch the RF channel from 3 to 4, accept settings, exit the wizard, tune in a station (at this point i start receiving audio, but no video). I then go back into the setup wizard and switch the rf channel back to channel 3, accept the settings, and at that point i have both audio and video. After this sage works beautifully, and incredibly stable. The only time i have to cycle through this is if i shut down sage or the computer. Sage 2.1 Hauppauge pvr 250 P4 3.0 Ati 9600xt Kingston DD400 512RAM Asus p4p800e 
|
|
#2
01-04-2005, 08:00 PM
|
|||
|
|||
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
