|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-25-2005, 12:02 AM
|
|||
|
|||
|
SageTVClient.gml ?
Quote:
Basically, it didn't work. I suspect that SageTV client uses different message codes (I mean, compared to SageTV, which works fine with SagetTV.gml). Whether this is true or not, does anybody have any experience controlling SageTV client with Girder ? Please share some hints. Thanks. Last edited by arylin; 02-25-2005 at 12:11 AM. 
|
|
#2
02-25-2005, 12:11 AM
|
||||
|
||||
|
The client uses a different Window Class name: SageClientApp
See the bottom of SageTV Girder Setup and/or p. 151 in the v2.1 manual (the bottom of the SageTV Commands intro page in Chapter 5). - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
