|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
05-10-2005, 09:47 AM
|
|||
|
|||
|
Hauppauge 250 and Dish Network
I am currently using a Hauppauge 250 with standard ananlog cable. I am considering switching to Dish Network. Will I need a different capture card in order to use the satellite signal?
Thanks in advance. 
|
|
#2
05-10-2005, 09:59 AM
|
||||
|
||||
|
You will be fine. But, if you are currently not using a box for your cable, you will need to get something to controll the Dish receiver--either a USB-UIRT or the Actisys 200L. Many prefer the USB-UIRT because it can control up to 3 different receivers. I do not think that Dish has serial control support which DirecTV does. This would only require a serial cable and is much faster than the blasters.
JUC
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
