|
|
|||||||
| SageTV Studio Discussion related to the SageTV Studio application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the Studio software application should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-11-2005, 04:59 AM
|
||||
|
||||
|
Which Capture device input was used for a recording?
How can I find out which capture device input was used to create a recording?
Consider: I have analogue cable on device #1, TV tuner input I also have analogue cable on device #2, TV tuner input I have a STB on device #2, S-Video input... I want to see if something was recorded from the STB, rather than from analogue cable... I can use GetMediaFileEncoding(MediaFile) to get the capture dev + the quality (and I can compare it with capture devs to strip off the quality), but I cannot see which input it came from... Any suggestions? (This is for an auto AR switcher that will switch AR based on recording name / channel / source)
__________________
Check out my enhancements for Sage in the Sage Customisations and Sageplugins Wiki 
|
|
#3
11-11-2005, 04:38 PM
|
||||
|
||||
|
Chick on the file after it's done, "recording detail", "Encoded By:" line on the right side shows the card. The panel above (with the time/date, duration) shows the channel of the recording- "1 Composite" is a security camera input on my system.
STBs may show the channel number above 100, then composite? I don't have a STB to confirm. Last edited by Menehune; 11-11-2005 at 04:43 PM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
