Fusion5 USB tuner: Is yours working?

jimwhite · #1 02-18-2006, 07:46 AM

Mine doesn't.... If yours does, then could you please post an attachment with your config file? I'm sooooo tired of banging my head on the wall.....

jimwhite · #2 02-19-2006, 07:37 AM

Nobody has this working?

aglennon · #3 02-19-2006, 01:17 PM

I can't get my Fusion-5 Gold card to work with Sage if that counts. I am about to go blow another 1/2 day trying again.

ellweber · #4 02-19-2006, 02:41 PM

Quote:

Originally Posted by jimwhite

Nobody has this working?

I do have this working. Not sure where your hangup is but if you can be more specific I will try to help. You do need to install the Fusion S/W first but it is probably unwise to try to run the Fusion application while Sage is running! The Fusion installer will set up the needed drivers and the Fusion Application will allow you to confirm that the hardware and drivers are working correctly before you try to use it from within Sage.

Lynn

jimwhite · #5 02-20-2006, 04:49 AM

I have the Fusion 3.3 software installed and it works fine.... the problem, as I reported in another thread, is that I get a Sage error, capture related, when it goes to put up a preview during the Source Setup.... can you post your sage.properties file??

ellweber · #6 02-20-2006, 11:37 AM

Quote:

Originally Posted by jimwhite

I have the Fusion 3.3 software installed and it works fine.... the problem, as I reported in another thread, is that I get a Sage error, capture related, when it goes to put up a preview during the Source Setup.... can you post your sage.properties file??

I have not seen much in the way of preview images but I do not get any error messages there. Sage properties attached with .txt added. I am running Sage service so this is the properties file for the service.

peterjb · #7 02-20-2006, 08:55 PM

Not sure if this is related - But given Dvico's driver track record it probably is...

I installed the FusionHDTV 3.3 drivers for my FusionHDTV DVB-T device and it has completely porked my ability to use this device under the current SageTV beta DVB-T support. It was previously working fine! It also now can't tune channels under the Fusion HDTV app that it used to under FusionHDTV 3.2 app.

I've rolled back to the 3.2 version of the application & drivers and all is well.

Cheers

Peter

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)