|
|
|||||||
| SageTV Beta Test Software Discussion related to BETA Releases of the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. regarding SageTV Beta Releases should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-19-2006, 11:26 AM
|
||||
|
||||
|
No locator ID
Hi,
Just installed the .10 beta. When I go into the server to find the locator ID it just comes back and says No locator ID was found. If I try and start placeshifter on a local machine with the IP address of the server I get a connection refused error message. I am sure this is simple, I have the Web server thingie still running on Sage if that might be it. I have no firewalls on the local network so I know its not that. Any help would be great. Thanks, Simon. 
|
|
#2
03-19-2006, 12:03 PM
|
||||
|
||||
|
After enabling the extender/placeshifter server, toggle the "SageTV Server" option off & then back on. It sounds like it wasn't fully enabled yet.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
