|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
05-12-2006, 09:38 PM
|
||||
|
||||
|
ir send message stops working...
I have been trying to resolve this ever since I purchased sage which was about 5 months ago. Basically if I sleep sage the sendmessage function that is built into the ir.exe of hauppauge's software stops working. Either that or sagetv stops accepting data from it.
I have submitted this error multiple times to SageTV's support site and I have tried just about everything... If anyone has a solution or has had this problem please help... It is not a focus problem either because I can alt tab back to sage and that does not fix it...
__________________
System (Windows Vista Ultimate): AMD Athlon 64 3500 / BFG Tech NF4S (nForce4 Ultra) / 4GB PC3200 / Sapphire ATI 2400PRO (Passive) Drives: 2x 500gb Seagate 7200.10 (Mirrored) / 1x NEC DVD-R/W PCI Cards: 1x Hauppauge PVR 150 & 1x Hauppauge HVR 1600 Remote: Media Center Remote / Keyboard Case: MCE-701 w/ 7-Inch Touchscreen 
|
|
#2
05-12-2006, 10:39 PM
|
||||
|
||||
|
It is an issue with the configuration of irremote.ini, not SageTV.
See a few posts before & after this post. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
