|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
05-22-2006, 11:50 AM
|
||||
|
||||
|
Sage properties
I tried to use placeshifter and was past the trial period and now everything (changes) seems to be written to sageclient instead of sage.properties. Is there a way to change this so everything is again written to sage.properties
 Thanks
|
|
#3
05-22-2006, 12:17 PM
|
||||
|
||||
|
You mean for SageTV running on your server PC? If you are using service mode, the UI portion will use sageclient.properties.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#4
05-22-2006, 01:37 PM
|
||||
|
||||
|
Quote:
|
|
#5
05-22-2006, 02:04 PM
|
||||
|
||||
|
The service uses sage.properties & the UI uses sageclient.properties -- this is covered towards the bottom of p. 16 in the v5 manual, with more details in Appendix A. Certain settings are always stored in sage.properties, but as long as you make those changes via the UI, the STV handles it automatically.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
