|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-02-2006, 10:41 PM
|
|||
|
|||
|
media file directories
I just upgraded to v5 am trying to import my media files. I have my pictures and music organized in subfolders under a common picture and music folder. Do I need to add each subfolder? I tried adding the parent folder, but it doesn't appear to have detected anything in the subfolders.
Thanks, DJM 
|
|
#2
06-02-2006, 11:05 PM
|
||||
|
||||
|
If you are adding the parent dir for both music & pictures, then you just need to add that single dir & make sure it is configured to import those media types in Detailed Setup -> General -> Import dirs.
It may need more time to scan, but are you using service mode? If so, make sure you are not using mapped drive letters. If you are using UNC paths, the service needs to log in as a user w/a password & have permission to access the path. If the service was configured to do this previously, then the installation reset it & you'll have to assign the user + password again. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
06-03-2006, 09:42 AM
|
|||
|
|||
|
Thanks. I am using service mode and was trying to import directories on drives local to the server. I changed both user running the service and changed the directories to use UNC paths and it appears to be working.
Thanks again!  DJM
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
