|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
08-21-2006, 08:09 PM
|
||||
|
||||
|
Running as service - client does not connect?
I am using the trial of 5.0.4, I want to run SageTv as a service and not use the UI - as stated on pg16 of the manual. When I attemp this the service starts fine, but the client will not connect it asks for the IP address - with or witout the UI started. I have to disable the service for the client to connect.
Edit: I am using MCE 2005 as an OS with all services disabled and processes ended. I ultimately want to run Sage on my server with 2 dual tunners but no UI running - is this possable? TIA -Skybolt 
|
|
#2
08-21-2006, 08:27 PM
|
||||
|
||||
|
If the client can connect in non-service mode, but not in service mode, then the first thing to check would be to make sure the service is allowed through your firewall. (SageTVService.exe)
You don't really need to run the UI at all on the server PC if using service mode... well, maybe it would help to use it for the initial configuration. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
