|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-09-2006, 08:59 AM
|
||||
|
||||
DUAL WinTV PVR 150 help
I recently built a PVR. And it works ... mostly.
 I only seem to have one hitch .... the 2nd PVR150 won't setup. I am using one card for STB output and one card for the cable from the wall. For the other card - I get the SAGE setup screens ok and it finds the 2nd card ... I select TV for the output .. it searches for the signal and shows me about 2 seconds worth -- and promptly locks up the system. Note that the 2nd card locks up no matter what input signal I try. I don't know if this matters -but I set up one card alone and recorded shows to make sure it worked before I installed the other card. Should I have installed them together? I have Updated the PVR drivers and Switched the PCI slots. I made sure there's no IRQ conflict. Didn't help. As far as I know I have the latest drivers for everything. Did I miss something obvious? Could this be a chipset issue? How do I find that out? Can anyone give me a clue as to what to try next? Thanks! Belle System Info: Celeron 1.7Mhz Biostar U8568 mobo (VIA P4X266E chipset) AGP Radeon 9100 768K memory 40 Gig IDE 400 gig SATA SageTv 5 2 PVR 150's (in PCI slots 1 and 2 respectively) 
|
|
#2
10-09-2006, 10:38 PM
|
||||
|
||||
|
issue resolved
Just wanted to let the board know I fixed it by updating the chipset drivers from the VIA website.
So if anyone else has this issue .... go here: VIA chipset drivers Belle
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
