|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-18-2006, 05:17 PM
|
|||
|
|||
|
sage can't find fusion lite board
Had to rebuild the system. I'm running sage 5.0 and it refuses to find the FusionLite board installed. The Fusion SW works, I can tune OTA channels so it's installed okay Sage, however, cannot see anything except the Hauppauge cards.
Any ideas on how to get it to recognize the fusionLite board? 
|
|
#3
11-19-2006, 02:31 PM
|
|||
|
|||
|
Yup, restarted, rebooted, nothing. Doesn't see the tuner card. Any way to force it to re-scan?
|
|
#4
11-19-2006, 03:41 PM
|
|||
|
|||
|
take a look in the sage.properties file.
Look for this line, mmc/ignore_encoders= . If your fusion card is listed there, shut down Sage completely and then delete the fusion card listing in that line. Then, when you restart Sage, it should "re-scan" to see if it can use the card.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
