|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-12-2007, 06:38 PM
|
|||
|
|||
|
"No Signal" problem
Hi,
I have a problem with my STV installation. I have a tv show in my favorites that's recorded 2 or 3 times a day at different time of the day. On most of the recording, the first five minutes are gone. After investigating the problem, I saw that when this tv show begins, STV hangs with a "No signal" message. After 5 minutes, the signal gets back. I was using STV v5 when this problem appears, but I've upgraded to v6 and I still have the No Signal problem. Someone have seen this problem before? 
|
|
#2
01-12-2007, 06:47 PM
|
||||
|
||||
|
What recording quality setting are you using? Try changing it.
Also, try changing the true or false setting of the seeker/fast_mux_switch property. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
