|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-20-2007, 02:15 AM
|
|||
|
|||
|
No signal after chaning channels
This problem was probably posted here somewhere, but I couldn't find it. I just upgraded to version 6.2 from a 5.x version, and everything works fine and I have video/sound... until I change the channel, then there is no video/sound and eventually it pops up a "no signal" message. But it will show me the video/sound again if I mess with the video settings or restart Sage... until I try changing the channel again.
I'm using the PVR-350 card with the latest drivers. Last edited by orrd; 11-20-2007 at 02:17 AM. 
|
|
#2
11-21-2007, 02:07 PM
|
|||
|
|||
|
Wow no reply to this? I thought there would be some kind of easy fix or it was a known bug. I can also add that Sage does start to see a signal after about 5 minutes (almost exactly 5 minutes), so all of my new recordings are missing the first 5 minutes.
|
|
#3
11-21-2007, 02:14 PM
|
||||
|
||||
|
If it is always 5 minutes, try setting the seeker/fast_mux_switch property to false, or try using a different recording quality.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DVBT No Signal on all channels with 6.0.14 | pschweig | SageTV Beta Test Software | 12 | 08-22-2007 12:19 AM |
| No signal on HD channels, need assistance please... | rtwhbw | SageTV Software | 3 | 05-07-2007 05:38 AM |
| Changing channels causes loss of signal | dtshedd | SageTV Software | 1 | 01-02-2007 07:22 PM |
| Some channels show no signal. | gump103 | SageTV United Kingdom | 2 | 06-14-2006 07:32 AM |
| Stutter/Jitter using A180/Vbox and OTA? Check signal "Strength" not "quality" | svemuri | Hardware Support | 0 | 12-13-2005 10:51 AM |
Linear Mode
