Multiple Hauppauge USB Tuners

[jwatsonx]

Hi, I have two USB tuners, a WinTV PVR2 and a brand new WinTV-HVR-1950. I am attempting to configure them both in an MC server but it seems almost like the drivers are conflicting with each other. The PVR2 was there first and works fine. The HVR-1950 appears to work ok with Hauppauge's WinTV software but I cannot get past the source config with Sage. It always hangs at "please wait for the preview to load". This is avery annoying and I'm not sure what to do next.

I have tried everything I can think of, removing devices running HWClear, reinstalling sources. I'm at a loss.


Any ideas???

John

[paulbeers]

Originally Posted by jwatsonx

Hi, I have two USB tuners, a WinTV PVR2 and a brand new WinTV-HVR-1950. I am attempting to configure them both in an MC server but it seems almost like the drivers are conflicting with each other. The PVR2 was there first and works fine. The HVR-1950 appears to work ok with Hauppauge's WinTV software but I cannot get past the source config with Sage. It always hangs at "please wait for the preview to load". This is avery annoying and I'm not sure what to do next.

I have tried everything I can think of, removing devices running HWClear, reinstalling sources. I'm at a loss.


Any ideas???

John

I don't see the HVR-1950 listed as an officially supported Tuner for Sage so that could be a problem....

Does it freeze up sage or just sit there trying to load the preview? If it doesn't freeze up Sage, try hitting escape when it states "please wait for the preview to load" and by pass this part of the setup. Then try recording two things at once to see if Sage just has a problem with the setup....