native resolution output mode and composite 480i down scaling

[proudx]

in the faq it says

Can multiple outputs be used on the STX-HD100 at the same time?

A: Sometimes.

In 480i mode; component, S-Video and composite are all active. But, simultaneous output may not be active for higher resolutions.

When HDMI is in use; only HDMI can be used (there are exceptions to this; but it depends upon the timing information supported by the HDMI display).


So my plan was to use native output resolution, however I would like to always have the composite output active so my slingbox can always have a 480i downrezed display feed to it.

So if I use component out at 1080i or 720p there will down rezed output to 480i via the composite output jack?

And if I was connected via hdmi, i'd not have any output to my composite output jacks?

what about the rca audio jacks, are they active at the same time as the ac3 jack?

just wanna make sure my slingbox has a constant 480i source and rca audio source "I know sage has its own placeshifter, but the slingbox works amazing on the slowest of connections"