SageTV Community  

Go Back   SageTV Community > Hardware Support > Hardware Support
Forum Rules FAQs Community Downloads Today's Posts Search

Notices

Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here.

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 11-29-2008, 02:15 PM
Humanzee's Avatar
Humanzee Humanzee is offline
Sage Fanatic
 
Join Date: Sep 2004
Location: North Idaho
Posts: 752
EVR fry my video card?

Hey, I've been running EVR since 6.5.2 and about a week into it my video card died and the computer turned off while watching sage. The computer wouldn't start with that video card in it. I took apart the client machine and put in a video card from my server and it started back up.

Is it plausible that since the dead video card was passively cooled, (Gigabyte Silent Pipe 8600GTS) the added load on the graphics chip using EVR pushed it over the edge? Over heated and fried itself?
Reply With Quote
  #2  
Old 11-29-2008, 04:39 PM
paulbeers paulbeers is offline
SageTVaholic
 
Join Date: Jun 2005
Posts: 2,550
Quote:
Originally Posted by Humanzee View Post
Hey, I've been running EVR since 6.5.2 and about a week into it my video card died and the computer turned off while watching sage. The computer wouldn't start with that video card in it. I took apart the client machine and put in a video card from my server and it started back up.

Is it plausible that since the dead video card was passively cooled, (Gigabyte Silent Pipe 8600GTS) the added load on the graphics chip using EVR pushed it over the edge? Over heated and fried itself?
Its possible. Most likely though this was going to happen sooner or later. It sounds like there isn't enough air movement in your case. The Passively cooled video cards usually run right on the edge of overheating and require quite a bit of air movement within your case in order to keep them from overheating especially if you keep your HTPC in a cabinet. I had lots of problems with a passively cooled Geforce 6600 until I put another fan in the case. It's kind of a catch 22.....do you add extra fans to the case to keep tthe air moving or do you just get a vid card with a fan on it? Usually though, case fans are quieter for the same volume of air movement because the fans are bigger and less restricted.
__________________
Sage Server: AMD Athlon II 630, Asrock 785G motherboard, 3GB of RAM, 500GB OS HD in RAID 1 and 2 - 750GB Recording Drives, HDHomerun, Avermedia HD Duet & 2-HDPVRs, and 9.0TB storage in RAID 5 via Dell Perc 5i for DVD storage
Source: Clear QAM and OTA for locals, 2-DishNetwork VIP211's
Clients: 2 Sage HD300's, 2 Sage HD200's, 2 Sage HD100's, 1 MediaMVP, and 1 Placeshifter
Reply With Quote
  #3  
Old 11-29-2008, 05:26 PM
HelenWeathers's Avatar
HelenWeathers HelenWeathers is offline
Sage Icon
 
Join Date: Aug 2008
Location: Miami, Florida
Posts: 1,321
I noticed that after about 20-30min of playback with my ASUS 9600 GT silent (passive) cooled card I would start to get pixelation and horizontal tearing. I temporarily pulled the card and ordered the following:

http://www.newegg.com/Product/Produc...82E16835118006

What a difference. And this fan has been very quiet in it's first month of use. Probably won't order a silent card again.
__________________
Server: SageTV 9, Win10/32, Intel DP55KG Mb, Intel QC i5 2.66GHz , 4GB 1333MHz DDR3 SDRAM, 2 Hauppauge 2255s for 4 OTA ATSC tuners, HDHRPrime w Comcast, 3 STP-HD300s 20101007-0 firmware, nVidia Shield. Java v7u55. Plugins:SD EPG, OpenDCT

Last edited by HelenWeathers; 11-29-2008 at 06:28 PM.
Reply With Quote
  #4  
Old 11-29-2008, 10:02 PM
Humanzee's Avatar
Humanzee Humanzee is offline
Sage Fanatic
 
Join Date: Sep 2004
Location: North Idaho
Posts: 752
Well, I just broke down and bought a 9800GT with a fan. I was there, it wasn't too expensive and the wife wanted her Sage back. Now we're back up and running again. The fan doesn't seem that loud, so I'll probably just keep it.

I would have thought that the old card would have had enough cooling passively. It was a double PCI slot design with the second bay taking up space just for cooling fins. The case has a pretty good design, but I guess it just doesn't pull that much past the cooling fins. The blu-ray drive is still the noisiest part of the case anyway.
Reply With Quote
  #5  
Old 11-30-2008, 08:13 PM
AJ Bertelson AJ Bertelson is offline
Sage Expert
 
Join Date: Dec 2003
Location: Maple Grove, MN
Posts: 532
Can one of you guys explain what EVR is to me? I have seen it mentioned a couple of times in regards to Ehanced Video Recording on wikipedia but I am bit confused. Is it on the client or the server side?

I read this and still am a bit confused
http://www.geektonic.com/2008/11/evr...ming-soon.html
Reply With Quote
  #6  
Old 11-30-2008, 10:42 PM
HelenWeathers's Avatar
HelenWeathers HelenWeathers is offline
Sage Icon
 
Join Date: Aug 2008
Location: Miami, Florida
Posts: 1,321
EVR is Ehanced Video Renderer, not recorder. It is a DirectX based technology that allows the operating system to offload the video processing from the cpu to the chip on the video card itself, taking the load off the cpu.

You need a video card that supports EVR, and an operating system and DirectX components that support EVR. Most newer video cards support EVR when coupled with an OS (Vista) that supports it.
__________________
Server: SageTV 9, Win10/32, Intel DP55KG Mb, Intel QC i5 2.66GHz , 4GB 1333MHz DDR3 SDRAM, 2 Hauppauge 2255s for 4 OTA ATSC tuners, HDHRPrime w Comcast, 3 STP-HD300s 20101007-0 firmware, nVidia Shield. Java v7u55. Plugins:SD EPG, OpenDCT
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
SageTV V6.3.10 Release Candidate Narflex SageTV Beta Test Software 0 02-28-2008 06:07 PM
Video Card Suggestions dbshelton Hardware Support 0 02-17-2008 02:27 PM
Replacement Video Card gmcomber Hardware Support 6 09-26-2007 11:10 AM
Video pixelization, lockups, BSODs, etc. Help! brianblank Hardware Support 5 01-31-2007 10:45 PM
Video Card Info mike_15 Hardware Support 0 01-16-2007 07:22 PM


All times are GMT -6. The time now is 12:47 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2023, vBulletin Solutions Inc.
Copyright 2003-2005 SageTV, LLC. All rights reserved.