|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-13-2009, 07:16 AM
|
|||
|
|||
|
Installation stuck at country select
Sagetv install gets stuck early on in the installation at the point where I select the country. I
get the circular symbol (sages hour glass) and cant mvoe from my selection. I've tried uninstalling and reinstalling and now get taken straight to that exact same stage and no further. I've even system restored back before the install but the problem persists. 
|
|
#2
01-13-2009, 08:25 AM
|
||||
|
||||
|
If you have a wireless keyboard or mouse, try disconnecting it. There have been posts in the past where a wireless keyboard was causing the Home command to be sent all the time.
And/or, be sure to remove the existing sage.properties file (may be in the Virtual Store if using Vista) to try a completely new config. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Capture card installation order? | JmpnJimBob | Hardware Support | 0 | 11-19-2008 12:12 PM |
| SageMC v6.3.8 Installation Survey | MeInMaui | SageMC Custom Interface | 20 | 11-08-2008 03:32 PM |
| Upgrading Installation Advice | Tenspeed | SageTV Software | 2 | 10-25-2008 12:12 PM |
| 3rd party remote, select button not working well (HD100) | Nate | Hardware Support | 1 | 02-29-2008 01:36 PM |
| Questions and issues regarding installation of 2nd HD Tuner | haubrija | Hardware Support | 0 | 09-25-2006 04:41 PM |
Linear Mode
