|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-16-2009, 12:36 PM
|
|||
|
|||
|
forced_video_storage_path_prefix
I'm using this to force my HD tuner to record to a specific drive, local to the machine. I've added a 2nd TB drive and want to allow the HD tuner to record to this one also. How do I specify two drives under forced_video_storage_path_prefix?
Currently is has: forced_video_storage_path_prefix=D:\ thx 
|
|
#2
02-16-2009, 01:12 PM
|
||||
|
||||
|
You can only specify a single prefix. If you want that prefix to match multiple drives on the same PC, then the best way would probably to use UNC paths & then use a prefix that matches both drives' recording paths.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| forced_video_storage_path_prefix - Is it possible to set local and UNC path? | zzmystique | SageTV Software | 3 | 06-07-2008 09:42 AM |
| Does forced_video_storage_path_prefix failover if full? | GollyJer | SageTV Software | 3 | 11-29-2007 07:04 PM |
| forced_video_storage_path_prefix | Wheemer | SageTV Software | 1 | 01-18-2007 06:22 PM |
Linear Mode
