|
|
|||||||
| SageTV Beta Test Software Discussion related to BETA Releases of the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. regarding SageTV Beta Releases should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-14-2004, 12:09 PM
|
||||
|
||||
|
help with epg configuration
I was looking on the configuration page inder support. and came accross something I would like to try
ui/default_epg_num_cols - num columns in the default EPG ui/default_epg_num_rows - num rows in the default EPG I input these two lines into properties file WHILE sagetv is shutdown ui/default_epg_num_cols=8 ui/default_epg_num_rows=8 But nothing happened and the lines were gone after opening sagetv again. I am sure it is just a syntax error, could someone please tell me what to input to get it right? 
|
|
#2
04-14-2004, 12:30 PM
|
||||
|
||||
|
The properties file undergoes changes & the docs for it haven't been kept up to date, so perhaps those settings are no longer used.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
