|
|
|||||||
| General Discussion General discussion about SageTV and related companies, products, and technologies. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
05-01-2004, 09:56 AM
|
||||
|
||||
|
IR Remote and Focus Application
Hi!
Has anyone encountered a problem where the IR Remote program (mine is the Haupauge one) will send codes to the current application that has focus rather than to SageTV? Has anyone figured out how to correct this? Karen
__________________
Intel Pentium 4@2.4 GHz Gigabyte GA8-IHXP 768 MB RDRAM NVidia GeForceX 5700 Hauppage WinTV PVR-350 1 TB Hard Drive space 
|
|
#2
05-01-2004, 02:58 PM
|
|||
|
|||
|
uh not with SageTV, it does have a way to do this with WinTV2000 though
if you hit the red button while using WinTV2000, it regains focus you might try to look at the setting of WinTV in the remote.ini and see if you can do the same for SageTV I know I will try it out if you do it but I watch pretty much always full screen
|
|
#3
05-01-2004, 03:34 PM
|
||||
|
||||
|
Re: IR Remote and Focus Application
Quote:
But, as long as you have a button assigned to start/run SageTV.exe, that button will bring SageTV back to the foreground & it will regain focus. Usually, this would be defined in the [Default] section of irremote.ini, but you could put it in the [SageTV] section too. A problem occurs when you are using the same remote button to both run and exit SageTV -- then this method may not work too well. The best solution is to use one button to start SageTV & another to exit/sleep. Then, you would use the ON button (defined in both [Default] and [SageTV]) to run/restore focus & the OFF button to only sleep/exit. There is more information regarding using the Hauppauge remote & editing its irremote.ini file at the links in this FAQ entry. Update: there is now a way to use the Hauppauge remote without requiring SageTV to have focus. See this FAQ entry. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. Last edited by Opus4; 05-18-2004 at 08:40 PM.
|
|
#4
05-03-2004, 12:08 AM
|
||||
|
||||
|
Yhanks for the advice guys!! After a bit more research I installed the Girder application and now all the problems have gone away. Thanks again!
Karen
__________________
Intel Pentium 4@2.4 GHz Gigabyte GA8-IHXP 768 MB RDRAM NVidia GeForceX 5700 Hauppage WinTV PVR-350 1 TB Hard Drive space
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
