|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
09-06-2004, 10:31 PM
|
|||
|
|||
|
Channel Changing - interrupt software "Message"?
What method does Sage use to change the channel from the EPG.
You can direct these to a USB-UIRT, so could you interupt that message and redirect it to girder? (and if so how?) Is it a Sage send message? Thanks Jeff 
|
|
#2
09-06-2004, 11:12 PM
|
||||
|
||||
|
There is an EXETunerPLugin download on the SageTV Configuration page -- look at the bottom of the right-hand side. That might be what you are looking for. You can search the forum for more info on it, if it is what you want.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
