Problem changing channels.

[Unpentium]

I can only select the channel I want to watch one time (when I first start Sage TV). The picture comes up fine and the program appears to be running normal. The problem comes when I want to change to a different channel. Let's say, for example I want to watch channel 206. When Sage TV starts, I go to the channel guide and navigate to 206 and click it. Channel 206 plays fine. If I want to change channels, I can't. If I try to change the channel, sage TV says that the channel is changing, but it doesn't change the channel on the DTV receiver. (I'm using the low speed data port on the STB and it's connected to the serial port on my PC).

Now...if I exit Sage TV, then reopen it and go to the channel guide, I can pick any channel and it will go to that channel. If I go to change channels once I'm watching something, the same problem happens. Any suggestions? Thanks in advance.

[Opus4]

Perhaps check this thread (near the end, post #25) or this one. Those changes probably require the v3 beta.

- Andy