|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
08-04-2007, 04:52 PM
|
|||
|
|||
Can't configure with SA2200 & USB-UIRT
Hi -
I've just downloaded SageTV, and am trying to configure it to control my SA2200 cable box through my USB-UIRT. Everytime SageTV tells me to point the remote at the USB-UIRT and press "0", after holding down the "0" key, it says there was an error learning the code. SageTV recognizes input from my StreamZap remote through the USB-UIRT just fine, but can't seem to see the signal from my cable remote. I'm hoping to convert from BeyondTV to SageTV, and any help would be appreciated. 
|
|
#2
08-07-2007, 06:50 PM
|
|||
|
|||
I got it to work, I just needed to hold the STB remote really close to the USB-UIRT.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| USB UIRT intermittently stops working till a full system reboot | ron.smythe | Hardware Support | 18 | 10-31-2009 03:02 PM |
| IR Blaster USB UIRT not waking STB up | 2FarGone | Hardware Support | 4 | 06-11-2007 08:11 AM |
| Problems controlling DEC-3000S with USB UIRT | oaamaas | Hardware Support | 2 | 04-10-2007 01:52 PM |
| USB UIRT not always tuning | phunny | Hardware Support | 3 | 03-24-2007 07:51 AM |
| Usb Uirt doesn´t work in Sagetv Service mode in V4 | Nadim | Hardware Support | 3 | 12-08-2005 12:32 AM |
Linear Mode
