|
|
|||||||
| SageTV Media Extender Discussion related to any SageTV Media Extender used directly by SageTV. Questions, issues, problems, suggestions, etc. relating to a SageTV supported media extender should be posted here. Use the SageTV HD Theater - Media Player forum for issues related to using an HD Theater while not connected to a SageTV server. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
08-07-2008, 05:03 PM
|
|||
|
|||
|
Power light blinking
My HD100 has worked fine since I bought it in late december, 2007 till last week. I turned it on, but I only get a slow blinking red power light. I can not get any picture at all on the tv, only the blue background indicating no signal sent. I have checked and rechecked wiring and it is good.
I have a Vizio 47" 1080p tv. The tv works fine off the SA 8300 HD cable box on Component 2. The HD100 is on Component 1. My question is (after reading the 10 page manual): What does the blinking power light indicate (no other lights)? I would appreciate any ideas or next step to take. 
|
|
#2
08-07-2008, 05:30 PM
|
||||
|
||||
|
There is a reset procedure in the manual & a more involved one in the FAQ topic at the top of this forum section. I would try resetting it & if that doesn't help at least load the HD100's server list menu, then you should contact support.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
08-08-2008, 06:45 AM
|
|||
|
|||
|
Blinking Power Light
I tried both procedures. The only activity I can detect is a very slow blinking red power light. Next step?
Should I just contact support via the SageTV support page? It seems intended for the SageTV software, not STX HD100 support.
|
|
#4
08-08-2008, 07:14 AM
|
||||
|
||||
|
Quote:
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HD Homerun Power Supply | Eckwell | Hardware Support | 12 | 09-10-2008 08:28 AM |
| Scheduled power management setting changes | steven017 | Hardware Support | 0 | 01-31-2008 09:58 PM |
| How many forum members does it take to change a light bulb? | spanky | The SageTV Community | 62 | 03-13-2007 08:16 AM |
| Issue with MVP soft power off/on in 6.1.3 | spacecadet | SageTV Beta Test Software | 7 | 03-08-2007 11:05 AM |
| Make sure your Power Supply is up to the task! | ke6guj | Hardware Support | 6 | 03-13-2006 11:43 AM |
Linear Mode
