WinTV PVR USB2 under Mac - poor Signal

[wescht]

Hi,
i'm trying to get my wintv pvr usb2 to work under mac os.

I have Boot Camp installed, and it works perfectly under XP. So the Signal / Cable / Hardware etc. is not the Problem.

Under Mac OS, the software reports that no channels were found when doing a scan. I tried both Cable and Antenna options.

Under MyTV/x, i can see twisted images on some channels, just as if the signal was very poor.

System Profiler says:

  Produkt-ID:	0x2400
  Hersteller-ID:	0x2040  (Hauppauge Computer Works, Inc.)
  Version:	8.00
  Seriennummer:	2401-00-008304CC
  Geschwindigkeit:	Bis zu 480 MBit/s
  Hersteller:	Hauppauge
  Standort-ID:	0xfd300000
  Verfügbare Stromstärke (mA):	500
  Erforderliche Stromstärke (mA):	0

Any suggestions?

[sandor]

http://forums.sagetv.com/forums/showthread.php?t=25116


don't know if it will work on the Mac side without support from Hauppauge

[wescht]

???

It's one (out of two) supported devices for mac.
http://www.sagetv.com/requirements.html?sageSub=tv

[sandor]

are you using the EskapeLabs Macintosh drivers?

http://www.hauppauge.com/site/suppor...t_mytvpvr.html

[wescht]

Yes I do. Which other drivers could I use?

I have MyTV/X 4.0.8 installed. Just like I mentioned in my first post:

Originally Posted by wescht

Hi,
Under MyTV/x, i can see twisted images on some channels, just as if the signal was very poor.

... which is the reason why I opened this thread.