HD200: Force Reset To Defaults?

[PeteCress]

HD200 on the kitchen TV via HDMI started acting goofy. 1080p.

Swapped it out for a spare and all is well in the kitchen.

But now I'm trying to troubleshoot the bad box on a TV that needs RGB input (does not have HDMI).

I get the Sage splash screen, followed by the "...is starting up.." for a few minutes; but then the screen goes to "NOT COMPATIBLE WITH THIS SIGNAL" which I take to be the TV's way of telling me something's out of it's league video-wise. My money would be on 1080i.... since this is a fairly ancient LED set and probably does 720 or maybe even 480.

So, bottom line, is there some magic I can work to make the HD200 revert to the way it came from the factory without going through it's UI?

[stanger89]

Try hitting the video out button the remote to see if that will toggle it to a mode that's supported. Otherwise the reset procedure is in the manual, but I think it's something like holding down delete while you plug it in (to power).

[PeteCress]

Originally Posted by stanger89

Try hitting the video out button the remote to see if that will toggle it to a mode that's supported. Otherwise the reset procedure is in the manual, but I think it's something like holding down delete while you plug it in (to power).

Found the manual.

Holding down Delete during powerup was the ticket.

Thanks.