|
General Discussion General discussion about SageTV and related companies, products, and technologies. |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
New driver install, no SageTV?
I replaced my old Hauppauge PVR350 drivers using the instructions on their website. That is, I wiped clean the old drivers using the "cleaning" software, restarted, installed the new drivers, installed the additional driver software, and finally installed the Hauppauge applications. The drivers and software work fine. The problem is that Sage doesn't recognize any longer that I have the PVR350 card in the system. When I go to do the set up, no card is in the list. Any pointers on what to do from here?
--Brent |
#2
|
||||
|
||||
have try going to setup and re-run the setup wizard?.
|
#3
|
|||
|
|||
Yes...that's just it...I go to setup, and no card appears in the list...
|
#4
|
|||
|
|||
In the Sage properties file look for the ignore list and your card should be listed after it. Simply delete the card name and it will be back. This normally happens if you are running sage when you remove the encoder or run sage without it reinstalled (as you do if you have Sage automatically starting up after reboot)
Matt |
#5
|
|||
|
|||
Thanks, Matt. I'll try that when I get home tonite!
--Brent |
#6
|
|||
|
|||
Matt--
That fix worked perfectly. Thanks again! --Brent |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|