|
|
|||||||
| SageTV Beta Test Software Discussion related to BETA Releases of the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. regarding SageTV Beta Releases should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
05-24-2008, 10:26 AM
|
|||
|
|||
|
V6.4.3 beta can't change HDHomeRun channel
Just installed SageTV V6.4.3 beta and am now unable to change channels on my HDHomeRun tuner from SageTV. I can use the HDHomeRun GUI to set a channel, and SageTV views it -- SageTV just can't control which channel to view. V6.3.10 worked (able to change channel).
I tried removing both sources from the SageTV source setup, and adding back -- same problem. 
|
|
#2
05-24-2008, 10:32 AM
|
||||
|
||||
|
not sure what to say, but I archived my 6.3.10 last night, and loaded up the 6.4.3 beta, and then when I did the HDHomerun Setup, I told it to scan for channels, and it only found the 8 QAM channels that I had previously setup in the SiliconDust app, and I mapped those to what I wanted, no issues.
I basically started over completely, and only copied over the wiz.bin file into my new installation.
__________________
SageTV Server - Q6600, 2GB Ram, 2x 750GB recording, HDHomerun 2xQAM, PVR-USB2, 2x HD-PVR, USB-UIRT controller 2 HD boxes and one SD box 3x HD100 HD Extenders
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Increase priority for channel changing? | Jackal24 | SageTV Software | 0 | 03-09-2007 12:57 PM |
| USB-UIRT & DCT6412 channel change problem | johnnyspo | Hardware Support | 4 | 01-18-2007 09:27 AM |
| Cannot change Server channel while Client is viewing TV | smokescreen | SageTV Software | 3 | 01-06-2007 04:47 PM |
| Channel change failure with PVR500 | Stobor | Hardware Support | 1 | 07-24-2006 03:56 PM |
| How to get a clean channel change | bob_s | SageTV Software | 8 | 05-18-2006 08:09 AM |
Linear Mode
