HD-100 Overscan problems with new beta firmware

[AzJazz]

I just updated my HD-100 with the 20090504 beta software yesterday.

Now, every time I go through the Setup screens, the display seems a little off-center. When I go to the "Overscan" settings, they are almost always different from what I had just set them to just a few minutes before.

I've never had this problem before; In the past, I never had to adjust the Overscan settings on my plasma TV - the default settings were always correct for my 16x9 screen.

Is this a known problem?

[razrsharpe]

I don't have any new overscan issues. I used to have an issue where every time i went back to the overscan settings they would be off and i could see the ui was off center. I eventually tracked it down to the orbiter on my plasma. Turned that off and no more issue The orbiter shifts the picture relative to the screen to prevent image retention (mine seems to shift it at most sceen changes - everytime the picture is black). Personally i think image retension is a sham with modern plasma if your not watching CNN (or something else with static content) ALL day long.

[AzJazz]

Sorry. It was cockpit problems.