HDHR tuning issue

[jerryb33]

Just received a HDHR over the weekend and put it into my Sage system on Saturday.
Running :
1800 (OTA)
1600 (OTA)
950Q(OTA)
SA8250 - HD PVR with Firewire channel change.
HD100 (2)

First problem (for info to other nubies) was with my D-Link router. Had to find MAC address for the HDHR. Simple, just went into my router "logs" and found what was trying to use it. Added it and I was able to get the NET lite up. D/L latest Firmware (1-2010) and installed it.

As per instructions, went straight to Sage and scanned both tuners, using my channels form my other cards. I noticed that one of my channels 14-**-* Fox aff. did not come in. When I went to my channel setup it was Highlighted so I taught nothing of it. I put the merit of the new tuner above my older cards. Went to watch what I assumed I recorded -24- last night. It was blank. Went into setup of the new tuners and re-scanned. No new channels were found, only the previous ones that I had scanned before. So I previewed each tuner to the Fox station. They came in and very good signal.

Now my question is "Will I lose the scanned channels or are they saved somewhere?"

[jerryb33]

I found the *.frq files for my tuners after some reading. LOL

Looking at the Silicon Dust frqs, I don't have the afore mentioned channels in either tuner. I went to my other tuners and it is in there frq.
I did re-scan the HDHR tuners on 1/26, but the file is still dated 1/24.
I do get 100% signal strength when I try to preview them.

What would my next step be?
1. Opus wrote to just copy a frq from another tuner. Did that mean copy from tuner 1 to tuner 2 or could I copy the missing channels from say my 1600 card to both HDHR tuners.

2. Remove the frqs and rescan

Currently running 6.59, but like to clear this up before upgrading to 6.62

Thanks