Using Remote numbers\letters to set focus.

[jaminben]

Hello,

I've setup a SetFocusForVariable (with EnsureVisibilityForVariable ) to quick jump to items within a table using keyboard letters which works fine and I also did the samething using my MCE remote....e.g you push 8 three times and it jumps to items with the letter "K". However when I went and tested with an extender I noticed the letters on the Sage remote don't corrispond to the same letters as the MCE remote for the same number.

Is there an easy solution to say.... If using remote "A" use these letters or if using remote "B" use these letters for the pushed remote number?

Cheers

Ben

[Opus4]

The MCE remote has the letter K on the number 8? Every remote I've seen, including an MCE remote, has 'JKL' on number 5, just like a phone... unless the letter assignments are different in the UK? But, a quick google search showed them to be similar, if not the same.

You should just be able to use the NTE number pad letter assignments for any number entry. But, if the letter assignments on your number pad are different, then you could try reassigning the NTE number/letter properties.

- Andy

[Bagal]

Originally Posted by Opus4

unless the letter assignments are different in the UK?

All my remotes including MCE ones have JKL on number 5...

[jaminben]

Yep, my mistake.... I was looking at it wrong.