Not waking the server from the HD300

[jjstok]

I've set up v9 on a w10 machine. In sleep mode the HD300 will not wake the PC. I've tested waking with magic packets and the PC wakes just fine. It also wakes to record.

I have entered the mac in both sage.properties and sageclient.properties and no change.

One thing I notice is upon starting the sage service again the sage.properties entry adds slashes... forced_mac_address=1c\:1c\:4b\:5b\:83\:48. the sageclient.properties does not forced_mac_address=1c:1c:4b:5b:83:48.

I used wireshark on the PC to capture the attempt while awake and it's hitting the right mac but I'm not sure how helpful that is.

Any other ideas?

[Tiki]

Originally Posted by jjstok

I've set up v9 on a w10 machine. In sleep mode the HD300 will not wake the PC. I've tested waking with magic packets and the PC wakes just fine. It also wakes to record.

I have entered the mac in both sage.properties and sageclient.properties and no change.

One thing I notice is upon starting the sage service again the sage.properties entry adds slashes... forced_mac_address=1c\:1c\:4b\:5b\:83\:48. the sageclient.properties does not forced_mac_address=1c:1c:4b:5b:83:48.

I used wireshark on the PC to capture the attempt while awake and it's hitting the right mac but I'm not sure how helpful that is.

Any other ideas?

Did you try adding slashes to the sageclient.properties file?

[wayner]

Originally Posted by jjstok

Any other ideas?

Don't bother putting the computer to sleep.