HD200 continuous reboot after firmware update

[jessecoffey]

Hey guys, just bought an hd200 a couple weeks ago, went to do the firmware update as it was recommended as apart of me updating to the latest beta for sagetv server. (updated to latest beta firmware via standalone mode settings menu)

Everything went by what the manual said would happen as i did it. Downloaded, erased 1/2, wrote 1/2, erased 2/2, wrote 2/2, then rebooted.

And it has never worked since. All it does is goes to a large SageTV logo that is fixed in the middle of the screen. Will flash blue (assuming no input, as its the color that my tv shows for that), then black for a few seconds, then to the logo for about 30 seconds.

So far I've, configuration reset as explained in the manual. Unplugged the box from my network. tried configuration reset again. Still nothin.

I put in a ticket, but it being so close to the weekend, i was hoping somewhere on here knew a little trick to completely reset the device to factory defaults or something.

Thanks in advance,
Jesse

[gplasky]

Did you press the Video Out button on the remote to cycle thru the video settings until you get something on screen?

Gerry

[jessecoffey]

I did, but it never leaves 1080i (i usually have it on 1080p) and I only know this because everytime it reboots my tv tells me the input. I do see the sage logo on screen. I have pressed the video out button to swap through (as thats what the config reset tells you to do) but it never changes off 1080i. So im guessing the device is never actually completing the boot up process and im assuming its due to the firmware update somehow.

I would be nice if there was some kinda of factory default reset option.

Thanks for the help so far,
Jesse

[Narflex]

Try the recovery procedure in the Media Extender FAQ

http://forums.sage.tv/forums/showthr...237#post323237