Trying to figure how to map HDHR channels right

[madpoet]

Sorry guys, new Sage user (well, very old Sage user but I haven't used it in 7 years or so!). I have an HDHomerun with 1 tuner active, attached to Cable and getting my ClearQAM channels that are available on the wire even though I only have a cable modem What I don't understand is how I make the association between the channels the HDHomeRun picks up and says are available and the channels in Sage. I set up the HDHomerun and scanned everything. The channel names are all correct. I added the tuner in Sage, and it wants me to select my cable system. Do I need to somehow map the standard cable channels to the frequencies HDHomerun detected?

[madpoet]

Ok, progress... I went back and chose the source as Digital instead of Basic and it seems to have picked up the channel list when I did the scan in Sage that had already been picked up in HDHomerun. Unfortunately I don't get any signal I can watch the channels fine in the HDHomerun preview app so it's definately got signal.

[madpoet]

Did this... didn't help:

http://forums.sage.tv/forums/showthr...5&postcount=15

[sTVb]

Originally Posted by madpoet

Did this... didn't help:

http://forums.sage.tv/forums/showthr...5&postcount=15

Did you follow the instructions from Opus' tuner tips sticky? It's a little old but I don't think a whole lot has changed from the user end of the setup.

Make sure your channel names match exactly. Also, if you map your channel #'s in the HDHR setup to match your cable system it can save a lot of potential headaches in Sage.

[madpoet]

Thanks. I updated my graphics drivers and rebooted and suddenly my channels displayed just fine. *shrug* Chalk it up to experience Just wish Comcast didn't encrypt the HD versions