USB-UIRT Tunes Only #7 on both STBs

smitz · #1 10-10-2010, 06:25 PM

I have two Verizon FIOS STBs (QIP2500-3) being controlled by USB-UIRT. Each STB can be tuned to any channel independently unless the channel has #7 in it. When the USB-UIRT tunes #7, it sends it to both boxes. Anyone else have this problem?

Spectrum · #2 10-10-2010, 11:41 PM

It sounds like the remote code for 7 is being broadcast to multiple zones. Look in your config file

Code:

...SageTV\Common\RemoteCodes\USB-UIRT Transceiver\{YOUR_config}.ir

and make sure that the entry for 7 has the correct zone info.

It should be something like

Code:

7 Z20000 ... 0D2B

That's for zone 2. If there is no Z* (where * is the zone number) it will broadcast it to all zones I think

smitz · #3 10-11-2010, 10:51 PM

That was it Spectrum. My USB-UIRT has worked so great I forgot about the initial setup of the zones. Z2 was missing from my 2nd STB config. I also found that Z1 was missing from a couple numbers in my 1st STB config.

Thanks for your help.

Spectrum · #4 10-12-2010, 02:23 PM

Quite welcome. It's always the little things

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MODIFIED: Simple Utility to Control Multiple DirecTV STBs via USB or Serial ports	jchiso	Hardware Support	10	07-05-2013 04:07 PM
Simple utility to control multiple USB or Serial HD DirecTV STBs	jchiso	Hardware Support	15	02-19-2009 06:27 PM
USB-UIRT, BellExpressVu and STBs woes	jesse_breaker	Hardware Support	1	02-06-2007 11:05 PM
SageTV, USB-UIRT, 2 6200 STBs... how do I control both independently?	reboot_this	Hardware Support	2	10-02-2004 01:29 PM
UIRT & Actisys for two STBs - No working	oshapir	Hardware Support	8	06-22-2004 12:34 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)