Odd HD-100 Behavior

[unkyjoe]

Greetings,

Due to a tuner card failure I was forced to install a clean version of Sage on a new WHS server and hardware.

Everything went fine, however when running through the wizard on the HD-100 for the initial Sage setup, I get to the point where it asks you your location information for the weather, if I enter my Zipcode and hit the ok button the screen on the HD-100 goes black and will not respond to the remote.

I am forced to power cycle the hd-100 and then start again, this time I skipped this step and instead moved forward, then the HD-100 got to the point on the wizard where it asks about the video quality, once I go into the wizard the screen goes blank and requires a power cycle again.

I skipped over this portion of the wizard and was able to get Sage running, so I went to the MVP unit in the bedroom and tried the wizard there, I get the same issue when trying to setup the video record quality, the unit gives a blank screen and will not respond.

I have turned logging on but can see nothing in the log that would indicate the problem.

P.S. The firewall on the WHS is disabled and it made no difference.

Thanks for your help.