|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-10-2011, 07:13 AM
|
||||
|
||||
|
For those of you with network encoders that temporary receive the message "No signal"
This is particularly useful for R5000 users; as, it takes 1-2 seconds to see video; hence, seeing the misleading message, "no signal". You can change the message to read, "Tuning in, please stand by..."
http://forums.sagetv.com/forums/showthread.php?t=53431 -MKANET
__________________
Upgraded to Comcast X1 + Netflix/Amazon Video streaming ***RIP SageTV*** 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does anyone know how to disable, delay, rename the "No Signal" message? | mkanet | SageTV v7 Customizations | 3 | 01-10-2011 07:23 AM |
| SageMC "OK" message on main menu. Error message? | 49studebaker | SageMC Custom Interface | 7 | 01-31-2009 09:50 AM |
| "No Signal" from Network Encoder on Audio-Only MPGs | derpderpy | SageTV Software | 2 | 10-04-2007 10:04 PM |
| Stutter/Jitter using A180/Vbox and OTA? Check signal "Strength" not "quality" | svemuri | Hardware Support | 0 | 12-13-2005 10:51 AM |
| ERROR (-9): All encoders are in use by clients viewing "Live" TV". | band80 | SageTV Software | 4 | 01-17-2005 01:59 PM |
Linear Mode
